Fitting your 20 litre solo micro-wave and 20 litre combination microwave oven

Fitting guide

Step 1

Remove the two drawers from the front of your kitchen.

Step 2

Fix the upper filler plate as shown using the two self drilling screws supplied

Step 3

Fix the locking plate to the rear of the combi using the microwave screws as shown. Screw the two 10mm screws into plate leaving 5mm of thread showing. Slot the combi into place and the heads will drop through the keyholes on the kitchen shelf.

Pull the combi into its final position and tighten the screws form the underside to secure the combi in place.

Step 4

Replace the two drawers, if the drawers foul the lower section of the combi you may have to adjust the drawer fronts.

There are 5 screws on the inside of each drawer front that re- quire loosening to adjust the drawer front, when correct position is found tighten the screws and fit the two drawers.


We hope this kitchen fitting guide has simplified the process of installing your purchase. Feel free to contact us if you do have any problems and require any further kitchen fitting advice. Once you have experience in fitting kitchen units, you may find similar jobs much easier to complete in future.